A'PEX SUPER AFC ? Bedienerhandbuch PDF herunterladen (Seite 52)

Select

End the check

Select [Pr] in the popup

menu after pressing the

center pushbutton or press

the left part of the center

switch, and the etc. menu

will reappear.

In-1 Airflow sensor voltage 1

Pressure sensor voltage

In-2 Airflow sensor voltage 2

(For a twin airflow car only)

Thrt Throttle sensor voltage

(For a car with a throttle sensor only)

Knk Knocking sensor output value

(For a car with a knocking sensor only)

The airflow sensor voltage, pressure sensor voltage, throttle sensor voltage, and knocking

sensor output value are checked.

After wiring, each connection can be checked for normality and each sensor status can be

checked. When setting the throttle sensor type on the previous page, it is necessary to

check the throttle sensor voltage.

Regarding a vehicle provided with multiple knocking sensors, the sensor output value of

each knocking sensor signal is checked, and wiring is performed to a sensor signal wire

with the highest output value.

２

Select [Sensor Chk] in the

etc. menu

１

Select [etc.] in the

main menu

Main menu

etc. menu

The sensor check mode is set

NOTE

●The knocking sensor output value is raw data including noise that was obtained

from the genuine knocking sensor. Accordingly, a higher numeric value than the

actual knocking level is displayed. This is not abnormal. (Not a knocking level)

Decide

Go back

【etc.】→【Sensor chk】

Sensor check

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Keine Kommentare

A'PEX SUPER AFC ? Bedienerhandbuch Seite 52